Udt Support For Dsb Blocks - Honeywell Experion PKS User Manual

7 DEVICE SUPPORT BLOCK (DSB)

7.11 UDT support for DSB blocks

With R410, you can create and configure user-defined templates (UDT) for any of the DSB block types. From
the Library view, you can right-click any of the DSB block and select Make Template. A new UDT for the
DSB block is added to the User library.
Template defining parameters for DSB block types
The following parameters are excluded from template defining for all DSB block types.
• AUXDESC
• FIELDNETWORKNUMBER
• MASKINGNETTAGNAME
• NETTAGNAME
• NETTAGPDCNAME
• PARENTASSET
• PDCPIOMBNAME
• RESETCOUNTERS
• SLAVEADDRESS
• PDCHASHCODE
• PDCDATAXML
For a Drive DSB, the following parameters are excluded from template defining.
• SECTIONTYPE
• SUBINDEX
For CEAG DSB, Siemens AS-I DSB, Siemens ET200 DSB, and Turck DSB block types, the following
parameter is excluded from template defining.
• ALARMDESC
Bulk Build support for DSB block types
The Bulk Build function is extended to support the DSB user-defined templates. You can create bulk copies of
the DSB user-defined template.
Attention
•
•
146 www.honeywell.com
The procedure for bulk building is identical to bulk building any other component. Refer to the Control Building
User's Guide for more information about bulk building.
You can also configure net tag names through Bulk Build operation. For more information, refer to the section
Configuring the field network tag names.