Modifying The Profibus Network Setup Values (Bus Parameters) - Honeywell Experion PKS User Manual

1 Click the Device Assignment menu in the Navigation Area.
2 Click Scan.
This reads information from the hardware through the network. Therefore, the PGM module must be
available and powered on before assigning a device.
After the scan is complete, the device information such as the chip type, the serial number, and the access
path is displayed.
3 Select the check box against the device that you must assign.
Click Apply.
4

6.4.2 Modifying the PROFIBUS network setup values (bus parameters)

1 Click the Bus Parameters menu in the Navigation Area.
The Bus Parameters details appear in the right pane. The Bus Parameters details contain the main setup
values of the PROFIBUS network. For more information on each parameters, refer to the PROFIBUS
website.
6 PROTOCOL BLOCK
71