Detail Display Tabs - Honeywell Experion PKS User Manual

To call the PGM block...
Secondary PGM Soft Failures tab
display
Secondary PGM Config details display Click the Config Details tab.

5.8.3 Detail display tabs

Main tab
From the Main tab detail display, you can navigate to the PBLink block detail display directly by clicking the
hyper-link provided for the PBLink_<> blocks.
You can modify the following values from the PGM Main tab detail display.
• Alarm Enable State.
• Temperature Threshold (this is not available in the secondary module detail display).
• Stack exceeded alarm.
• Controller Command.
• Reset Statistics (this is a push button).
Attention
The Main tab detail display of the redundant PGM is identical to the primary PGM Main tab detail display tab.
Then ...
Click the Soft Failures tab.
Figure 2: PGM Main tab display
5 PROFIBUS GATEWAY MODULE (PGM) BLOCK
51