Actuator Cable Adjustment; Clutch Switch Test - Honda CR-V 1997 Service Manual

Actuator Cable Adjustment
1. Check that the actuator cable operates smoothly
with no binding or sticki ng.
2. Start the engine. Hold the engine at 3,000 rpm with
no load IAfT in
[ffi
or
~
position, M(T i n neutral)
until the radiator fan comes on, then let it idle,
3. Measure the amount of movement of the actuator
rod until the cable pulls on th e accelerator lever
(engine speed starts to increase). Free play should
be 11
±
1.0 mm 10.43
±
0.04 inl .
ACTUATOR ROD
ADJusnNG NUT
LOCKNUT FREE PLAY: 11
±
1.0
mm
10.43
±
0.04 Inl
LOCKNUT
4. If free play is not with in specs, loosen the locknut,
and turn the adjusting nut as required .
NOTE : If necessary, check the throttle cable free
play (see section 11), then recheck the actuator rod
free play.
S. Retighten the locknut, and recheck the free play.
Clutch Switch Test
r:-:1
~
1. Disconnect the 2P connector from the clutch switch.
CLUTCH SWITCH 2P CONNECTOR
Terminal side of
male terminals
2. Remove the clutch switch.
3. Chec k for continuity between the termina ls accord-
ing to the table.
Terminal
\
2 3
Clutch Switch
DEPRESSED
RELEASED
4. If necessary, replace the sw itch or adjust the pedal
height Isee section 121.
4-43