Replace Front Panel; Equipment Required; Replacement Procedure - Honeywell Thor VM3 Manual

Replace Front Panel

Front Panel Options
The front panel of the Thor VM3 is field replaceable. The front panel assembly contains the keypad, touch screen and
optional defroster. Should any of these components fail, the front panel assembly can easily be replaced to reduce down-
time. The replacement front panel is available in several configurations:
• Standard temperature with resistive touch screen
• Cold storage with resistive touch screen
• Standard temperature with PCAP touch screen
• Outdoor with resistive touch screen
• Outdoor with PCAP touch screen
Note: The resistive and PCAP touch screens each use a unique stylus. If switching between touch screen types, be sure
to swap the stylus as well.

Equipment Required

The following equipment is user-supplied:
• Torquing tool capable of measuring inch pounds
• #2 Phillips screwdriver bit

Replacement Procedure

CAUTION - Before replacing the Thor VM3 front panel,
1. Place the Thor VM3 on a clean, well-lit surface before perform-
ing the front panel replacement.
2. Remove the Thor VM3 from the Smart Dock.
3. Disconnect UPS Battery
4. Loosen the sixteen (16) captive M3 screws holding the front
panel. Use a #2 Phillips bit.
(page 4-49).
Disconnect UPS Battery (page 4-49).
1 5
11
16
14
3 8
9 7 4
13
15
12
10 6 2
4 - 53