Honeywell Thor VM3 Manual page 124

UPS
When the Thor VM3 is operating on the UPS the timeouts from the battery section for the selected power scheme/
plan are used. By default, the timeouts for UPS are the same for each power scheme/plan.
UPS Behavior
The Thor VM3 behavior when operating from UPS power is described below.
Thor VM3 is Off
Conditions
The Thor VM3 is Off and the power button is pressed the Thor VM3 and the following condition is met:
• UPS power is over 35% capacity
Result
The Thor VM3 boots and follows the selected power scheme's Running on Batteries (or power plan's On
battery) timeouts with power management timers reset at boot up.
Conditions
The Thor VM3 is Off and the power button is pressed the Thor VM3 and the following condition is met:
• UPS power is under 35% capacity
Results
The Thor VM3 remains Off.
Thor VM3 is On
Conditions
The Thor VM3 is On and external power is removed, such as:
• Thor VM3 is removed from a powered dock (Dock power switch On)
• Thor VM3 is mounted to a dock and truck power is removed from the dock
• Thor VM3 is mounted to a dock and the dock power switch is turned Off
Result
The Thor VM3 boots and follows the selected power scheme's Running on Batteries (or power plan's On
battery) timeouts with power management timers reset at the time of power removal. UPS charging is
disabled.
Power Notification Icon
The Power icon in the notification area provides an indication of the level of UPS battery charge. The icon also
indicates if external power is connected. Some samples are shown below
External power is connected and the UPS battery is approximately 50% charged.
External power not connected and the UPS battery is approximately 100% charged.
5 - 26