Connect Usb Host; Connect Usb Client - Honeywell Thor VM3 Manual

Connect USB Host

Host / Client Y Cable
D9 Connector
See USB and USB1 Connector
Note: The USB client connection is not available on the Thor VM3.
1. Seat the D9 connector firmly over the USB (Standard Dock) or USB1 (Enhanced Dock) connector on the dock.
2. Tighten the thumbscrews in a clockwise direction. Do not over tighten.
3. The USB-host connector provides a connector for a USB device such as a USB thumb drive.
4. Secure the cables to the Thor VM3 with
Dual Host Y Cable
D15 Connector
See USB2 Connector
1. Seat the D15 connector firmly over the USB2 (Enhanced Dock only) connector on the dock.
2. Tighten the thumbscrews in a clockwise direction. Do not over tighten.
3. The USB-host connectors provide a connector for a USB device such as a USB thumb drive.
4. Secure the cables to the Thor VM3 with
USB Scanner
A USB scanner may be attached to the USB host port.
If using Enterprise Settings
plug it back into the USB port in order for the auto-detect function to display the scanner settings.

Connect USB Client

Note: The USB client connection is not used on the Thor VM3.
USB Host Connector
USB Client Connector
(page 9-7) for connector pinouts.
Strain Relief Cable Clamps
(page 9-8) for connector pinouts.
Strain Relief Cable Clamps
(page 5-10) to configure the USB scanner, it may be necessary to unplug the scanner and
(page 4-16).
USB Host Connectors
(page 4-16).
4 - 41