Bar Code Readers; Scanner (Virtual) Wedge; Touch Screen Calibration - Honeywell Thor VM3 Manual

Bar Code Readers

The Thor VM3 can use the following external bar code readers:
• Tethered hand-held scanners are tethered to a serial port or a USB host port (via a dongle cable) on the Thor VM3 Smart
Dock and are configured by scanning the engine-specific bar codes in the scanner manufacturer's programming guide. The
manufacturer's guides are usually shipped with the bar code reader.
• Wireless hand-held Bluetooth scanners are configured by scanning the engine-specific bar codes in the scanner
manufacturer's programming guide. The manufacturer's guides are usually shipped with the bar code reader.
• The body worn Bluetooth Ring Scanner module may be using a Symbol 4400 Ring Imager or a Symbol 955 Ring Scanner.
The BTRS module is configured by scanning the bar codes in the Bluetooth Ring Scanner Guide.

Scanner (Virtual) Wedge

Virtual wedge parameters are set via

Touch Screen Calibration

To calibrate the touch screen:
1. Browse to the C:\Honeywell\Touch_5W folder.
2. Tap HIDeGalaxTouch.exe.
3. Select 4 Points Calibration.
4. Follow the on screen instructions to touch the screen, hold the touch and then lift the stylus to complete the calibration
process.
5 - 42
Enterprise Settings (page 5-10).