Honeywell Thor VM3 Manual page 106

Manual
1. Select Bluetooth Scanning from the Control Panel (either large or small icon view option must be selected).
2. Tap Add Device.
3. Select Manual.
4. Tap Next.
5. Enter the MAC address of the Bluetooth scanner.
6. Tap Next.
Troubleshooting
• The Honeywell Xenon 1902 Bluetooth scanner does not work with Quick Connect. It must be connected using the
Search or Manual options.
• Make sure the scanner is in the correct mode. Bar codes to set the mode can be found in the manual provided with
the Bluetooth scanner.
» The scanner must be a master device to use the Quick Connect option.
» The scanner must be a slave device to use the Search or Manual option.
• The Motorola/Symbol LS3578 family of scanners may not support the Quick Connect feature (depending on firmware
installed). If Quick Connect does not work, use the other options to connect these scanners.
• If the Honeywell Granit 1911i and Granit 1981i scanners cannot be found with the Search option, scan the PDAs/
Mobility Systems Devices bar code from the scanner manual and search again.
• If the Honeywell Granit 1911i and Granit 1981i scanners cannot connect using the manual option, scan the PDAs/
Mobility Systems Devices bar code from the scanner manual then repeat the manual add process again.
• If the Honeywell Granit 1911i and Granit 1981i scanners are not removed after using the Remove option, the auto-
reconnect option is enabled on the Granit scanner (this is the default option). To remove the scanner:
» Scan the disable auto-reconnect bar code from the Granit scanner manual then tap Remove, or
» Scan BT_RMV to unlink and disconnect the scanner the tap Remove.
• If a Honeywell/LXE ring scanner is not connecting, scan the Restore Factory Defaults bar code in the scanner
manual and try connecting again.
Adding Other Scanners
Some scanners may not be supported/discoverable by Bluetooth Scanning. In this case, use the Microsoft Bluetooth
panels to add the scanner.
Note: The Microsoft Bluetooth panels should only be used when the scanner cannot be connected with one of the
methods listed above.
5 - 8