Power Controls; External Connectors - Honeywell Thor VM3 Manual

Power Controls

Power Switch
Standard Dock
Power Button

External Connectors

Power the Thor VM3 off before attaching a cable to any port (serial, USB, Audio/CAN, etc.).
The external I/O connectors for the Thor VM3 are located on the right side of the Smart Dock (when viewed from the back).
The Power Supply Connector
Antenna connectors are located on the top rear of the Thor VM3.
3 - 4
Enhanced Dock
(page 3-7) is on the left side of the dock (when viewed from the back).
After all cables are connected, the Thor VM3 can be powered on.
There is a power switch located on the back of the dock. The power
switch is a rocker switch.
The power switch has a raised bump to identify the switch position
even when it is hidden from view. When the side of the switch with
the raised bump is pressed, the power switch is On. If the dock is
connected to external power, the dock delivers power to the Thor
VM3.
Generally, once the dock is powered On, there is no need to power
it off. The dock power can remain On even when the Thor VM3 is
not attached.
The power button is located at the lower left of the Thor VM3.
If the Thor VM3 is Off, pressing the power button starts the power up
sequence.
Note: This assumes that the Thor VM3 is docked in a powered dock
or that the internal UPS battery has a sufficient charge to
power the Thor VM3. If no external power is available and the
UPS battery does not have a charge, pressing the power
button causes no action.
If the Thor VM3 is On, pressing the power button performs the option
selected in the Advanced tab of the Power control panel (options may
vary by OS type):
• Ignore power button press
• Prompt the user to select action
• Shut down (default, an orderly shutdown is performed)
• Standby/Sleep
• Hibernate