Honeywell Thor VM3 Manual page 113

Remap a Key to a Key Sequence
Up to 16 keys may be specified for the key sequence. The sequence can consist of keys and Unicode values.
1. Select the modifier key from the Modifier Mode options.
2. The key to be remapped is the programmable function (PF) key on the numeric keyboard.
3. Select Key Sequence from the pull-down list.
4. Select the first key for the multiple key sequence from the pull-down list.
5. Press the Add button to add the key to the multiple key sequence shown in the Key Sequence box.
6. Repeat this steps 4 and 5 until all desired keys have been added to the key sequence. If necessary, use the
Clear button to erase all entries in the Key Sequence box.
7. Click OK to save the result and close the control panel.
Remap a Key to a Sequence of Unicode Values
Up to 16 Unicode values may be specified for the key sequence. The sequence can consist of keys and Unicode
values.
1. Select the modifier key from the Modifier Mode options.
2. The key to be remapped is the programmable function (PF) key on the numeric keyboard.
3. Select Key Sequence from the pull-down list.
4. Select Unicode from the Key Sequence pull-down list.
5. There are two Unicode text boxes located on the lower part of this tab. Enter the Unicode value in the text box
to the right of ALT + and the Unicode character is displayed in the box to the right of =.
6. Press the Add button to add the key to the multiple key sequence shown in the Key Sequence box.
7. Repeat this steps 4 through 6 until all desired characters have been added to the key sequence. If necessary,
use the Clear button to erase all entries in the Key Sequence box.
8. Click OK to save the result and close the control panel.
Remap a Key to Launch an Application
1. Select the modifier key from the Modifier Mode options.
2. The key to be remapped is the programmable function (PF) key on the numeric keyboard.
3. Select Launch App1-2 from the remapped key from the Remapped Key pull-down list.
4. Make sure the APP radio button is selected.
5. In the text box (LaunchApp1-2) corresponding to the number selected for Launch App1-2, enter the application
to launch.
6. If any parameters are needed for the application, click on the OPT radio button. This clears the text box
(though the application name is saved). Enter the desired parameters in the appropriate text box.
7. Click OK to save the result and close the control panel.
8. If the KeyMap tab is accessed again, the application plus any specified parameters is displayed in the Key
Sequence text box when the remapped key is again selected.
5 - 15