Default User Codes; How To Log On The System; How To Log Off The System; Table 4-5: Default User Codes - Honeywell ADEMCO MX8000 Installation And Operation Manual

Note: See Section 4.6 for detailed information on the main menu options.
You must have at least one Installer Profile Code programmed in the system at all times.
4.4.3

Default User Codes

At initial power up, the system provides two default user codes. User code 1 defaults with an Installer profile
and user code 2 defaults with an Operator profile. Table 4–5 shows the default codes and their profiles.
*Note: User code 1 can be changed but not deleted. User code 1's profile will always remain as "installer".
4.4.4

How to log on the system.

Follows these steps to properly log on to the system:
LOG
1. Press the
STATUS
The VFD will display
2. Enter your PIN code. (See Table 4–5 for default codes.)
Note: This screen will time out after 15 seconds.
ENTER
3. Press the
MENU
If the correct PIN is entered the VFD will display
The "Operator Logged In" LED will also turn on.
If an invalid code is entered the VFD will display Access code not verified.
Note: If the previous user has not logged off, a new user can still log on by entering a PIN code. This will
automatically log off the previous user and log in the new user.
4.4.5

How to log off the system.

Follows these steps to properly log off the system:
LOG
1. Press the
STATUS
The VFD will display
Note: This screen will time out after 15 seconds.
2. Enter your PIN code. (See Table 4–5 for default codes.)
✔
✔
✔
✔
✔
✔
Table 4–5: Default User Codes
User Number
*1
2
button.
Enter Log In Code:
[ ]
button.
button.
#nn User Name
Log Out
[ ]
✔
System Info
✔
Set Time & Date
✔
System Restart
Printer Menu
Program Menu
Diagnostics
Default Code
Default Profile
(PIN)
8000 Installer
1111 Operator
Logged in as
Installer # XX
User Name.
Section 4 – Operation
4–5