Table of Contents
Advertisement
MX8000-3EX Installation and Operation Guide
Note: This feature should be disabled if the automation software package that you are using does not
recognize Hex data.
Follow these steps to enable or disable hex mode:
1. Enter program mode. (See Section 5.1.)
1
2. Press
for general options.
3
3. Press
for communications.
5
4. Press
to set up automation configuration.
5. Press
until the hex field is flashing.
6. Press the
or
ENTER
7. Press
.
MENU
8. If you wish to exit, press
How to Enable or Disable Heartbeat
A heartbeat is a supervisory signal that continually tests the communication link between the automation
computer and the receiver.
Follow these steps to enable or disable heartbeat:
1. Enter program mode. (See Section 5.1.)
1
2. Press
for general options.
3
3. Press
for communications.
5
4. Press
to set up automation configuration.
5. Press
until the heartbeat field is flashing.
6. Press the
or
ENTER
7. Press
.
MENU
8. If you wish to exit, press
Time (Period of Heartbeat)
This option determines how often the heartbeat is sent to the automation computer. For example, if the time
is set to 60 seconds (default setting) then a heartbeat will be sent every 60 seconds.
Follow these steps to set the time period or the heartbeat:
1. Enter program mode. (See Section 5.1.)
1
2. Press
for general options.
3. Press
3
for communications.
5
4. Press
to set up automation configuration.
5–18
button until the display flashes on the desired setting.
until you exit this menu.
button until the display flashes on the desired setting.
until you exit this menu.
Advertisement
Table of Contents
Troubleshooting
