Terminology; What's In The Box - Honeywell ADEMCO MX8000 Installation And Operation Manual

MX8000-3EX Installation and Operation Guide
1.6

Terminology

This section lists terminology that is specific to this product and their meaning.
Term
ACK
Automation Protocol
Communication Group
Heartbeat
Listen-in
Main Menu
MCPU
NACK
PIN
PZT
SBUS
VFD
1.7

What's in the Box

This section contains a list of the parts that are shipped with the MX8000–3EX receiver and a brief
description of their intended use.
Item
Battery/Alert Relay Wiring
Harness
MX8000–3EX Installation
and Operation Guide
Digital Alarm Receiver
Line Card (See Note)
Strain Relief Tie Wrap
Receiver Mounting Screws
Power Cable
1–4
Stands for acknowledgment.
The format used for messages sent between the receiver and the automation
computer.
The different types of communication are separated by handshake type. These
handshake types can be assigned in a numbered order. (See Section 5 for more
details.)
A supervisory signal that continually tests the communication link between the
automation computer and the receiver.
Listen-in is the ability to listen in to what is happening real-time from the central
station to a remote location. This can help the central station operator determine if he
or she should dispatch for a particular alarm situation.
The main menu will be displayed as either <Installer Menu> or <Operator Menu>.
However, this manual will refer to them as the main menu.
Master Central Processing Unit.
Stands for no acknowledgment.
An abbreviation for Personal Identification Number. PINs are used to log in and out
of the receiver.
PZT is an abbreviation for a piezo alert sounder.
Serial Bus interface to connect a MX8000–3EX receiver to line cards, the VFD
display and additional MX8000–3EX receivers via rear panel connectors.
Stands for Vacuum Fluorescent Display. This is the type of message display used on
the receiver.
Quantity
1 Wiring harness used to connect the MX8000–3EX receiver to a
backup battery. It also provides a normally open or normally closed
output for an alert sounder.
1 A manual covering installation and operation information related to
the MX8000–3EX receiver.
1 The digital alarm receiver assembly.
1 Line card for land lines.
1 Tie wrap used as a strain relief on the phone cord. See Figure 3–3
for location of strain relief tabs.
4 #10-32 x 1/2 flat head screws used to mount the receiver to a rack.
(See Section 3.5 for rack mounting instructions.)
1 AC power cable used to connect the MX8000–3EX receiver to an AC
wall plug.
Meaning
Description