Table of Contents
Advertisement
5. Press the
or
6. When the equal sign highlights the option you wish to change, press
Note: Additional presses of the enter button toggle the setting between "yes" or "no". See Table 5–8.
7. Repeat steps 5 through 6 for all annunciator options you wish to change. See Table 5–8 for list of
additional options.
5.3.3.7
How to Configure the Auxiliary Relay Outputs
Program what will give a trouble output to the auxiliary relay contact. (To program the normal state of the
auxiliary relay, see Section 5.3.4.)
Note: Pressing ACK will silence an alarm, (essentially acknowledging the event), but the only way to reset
the auxiliary relay contacts is to actually restore the trouble. As long as there are any troubles in the system,
the contacts will be set.
1. Enter program mode. (See Section 5.1.)
1
2. Press
for general options.
3
3. Press
for communications.
7
4. Press
to set relay configuration.
A list of the relay output options appears.
5. Press the
or
6. When the equal sign highlights the option you wish to change, press
Note: Additional presses of the enter button toggle the setting between "yes" or "no". See Table 5–8.
7. Repeat steps 5 through 6 for all relay options you wish to change. See Table 5–8 for list of additional
options.
Option
Printer
Bkp Printer
Auto Comp
Bkp Auto Comp
Battery
Device
Line Fault
AC Power
Buffer Full
Listen In
Call Pending
button to move through the annunciator output options.
button to move through the relay output options.
Table 5–8: On-board Annunciator and Auxiliary Relay Options
Choices
Y (Yes)/N (No)
Y = Annunciator will beep and relay energize if there is an error
condition.
Y (Yes)/N (No)
N = No on-board annunciation or relay energizing if an error
Y (Yes)/N (No)
condition exist.
Y (Yes)/N (No)
Y (Yes)/N (No)
Y (Yes)/N (No)
Y (Yes)/N (No)
Y (Yes)/N (No)
Y (Yes)/N (No)
Y (Yes)/N (No)
Y (Yes)/N (No)
Section 5 – Programming
ENTER
.
MENU
ENTER
.
MENU
Comments
5–21
Advertisement
Table of Contents
Troubleshooting
