Vfd Status Display; Table 4-3: Vfd And Printer Abbreviations; Figure 4-3: Vfd Display - Honeywell ADEMCO MX8000 Installation And Operation Manual

Call Pending
Line Port LED
(MX8000-LC3
4.2.2

VFD Status Display

The status display is a 4-line 20 character (each line) backlit VFD that shows the various alarm and function
messages. It functions in all modes of operation (normal and programming mode). As the MX8000–3EX
acknowledges calls and messages, it updates the calls on the VFD and silences the alert tone.
4.2.2.1 VFD Abbreviations
Many of the words used on the VFD are abbreviated to accommodate 20 characters per line. Table 4–3
compares the event that is reported to how it is output to the VFD and printer.
The acknowledge key
was pressed at least
once, but not all the
events in a call were
acknowledged.
Off
Red
Green Off Hook
MX8000 Receiver
Ademco
Man: Active
01/01/01
Figure 4–3: VFD Display
Table 4–3: VFD and Printer Abbreviations
Event
Alarm
Trouble
Restore
Supervisory
Opening
Closing
Remote
Disable
Bypass
Unbypass
Test
Listen-in
System
Access
Report
Cancel
Zone Number
Door Number
No calls pending or all
calls have been
acknowledged.
The line card is
operating normally.
08:32:44
VFD
Alrm Alarm
Trbl Trouble
Rstr Restore
Sprv Superv
Open Opening
Clos Close
Rmot Remote
Dsbl Disable
Byps Bypass
Ubyp Unbypass
Test Test
Lstn Listen
Sytm System
Accs Access
Rprt Report
Cncl Cancel
Z# Zone
D# Door
Section 4 – Operation
Calls pending.
Slow Flash – Uninitialized.
Fast Flash – Trouble
(Specifics available on
VFD).
Ring Detection – Flash
follows ring.
Listen-in – 1 sec. on, 1 sec
off.
Printer
4–3