Honeywell ADEMCO MX8000 Installation And Operation Manual page 114

MX8000-3EX Installation and Operation Guide
LC Sys
VFD Messages
Error Error
✔
Expander
Trouble
✔
Expander Trbl
Rst
✔
AC Trouble
✔
AC Trouble Rst
✔
Battery Low
Restore
✔
Battery Low
✔
Local Program
Begin
✔
Local Program
End
✔
Local Program
Fail
✔
Listen-in End
✔
Listen-in Begin
✔
System Date
Changed
✔
System Time
Changed
✔
Msg Queue Full Message Queue
✔
Msg Queue Full
restore
✔
Main Computer
Trbl
✔
Main Computer
Rst
7–2
Table 7–1: Error Messages (cont'd)
Printer Message
Expander Trouble Trouble with a device connected to the
SBUS.
Expander Trouble The trouble condition of a SBUS device was
Restore corrected.
AC Trouble AC power failure.
AC Trouble Restore AC power was restored.
Battery Low The backup battery power supply trouble
Restore has been corrected.
Battery Low The backup battery is checked continually
every second. This message would be
displayed if the backup battery were set to
"Battery Bkp". See Section 5.3.4. Indicates a
low battery when the voltage drops to 10.2
VDC or lower.
Local Program This message indicates the time a system
Begin User # "installer" entered program mode.
Local Program End This message indicates the time a system
User # "installer" exited program mode.
Local Program Fail The receiver will stay in program mode for
User #
15 minutes without any activity, then it will
time out and go back to normal mode. This
message indicates that an installer entered
programming and did not exit programming
before it timed out.
Listen-in End A listen-in session completed
Listen-in Begin A listen-in session started.
System Date An installer changed the system date.
Changed User #
System Time An installer changed the system time.
Changed User #
Messages can be sent to automation
Full
computer, a printer or can be manually
acknowledged. If one or more of these
devices does not respond to messages
being sent or manually acknowledged, the
message queue will fill up. When the
message queue is full the receiver will no
longer accept incoming calls.
Message Queue Indicates that the message queue full error
Full restore has been corrected.
Main Computer A communication problem exists between
Trouble the automation software and the receiver.
Main Computer The communication error between the
Restore receiver and the automation software has
been corrected.
Description What to Do
Check AC outlet and
AC power cord.
Restores at 12VDC
after a low battery
condition.
Check battery cables.
If they are OK
replace backup
battery.
Verify that messages
are acknowledged to
any printers,
automation software,
and while in manual
mode.
Check cable
connections. Verify
that the port is
configured properly.