Table 5-7: Iti Automation Format Options - Honeywell ADEMCO MX8000 Installation And Operation Manual

5. Press until the time field is flashing.
6. From the number keypad enter the desired number or press the
flashes on the desired setting.
ENTER
7. Press .
MENU
8. If you wish to exit, press
Ack Time (Acknowledge Time)
The acknowledge time is the duration that the receiver will wait for a response from the automation
computer after a data packet has been sent. Data packets include all reports and heartbeats.
Follow these steps to set the time period or the heartbeat:
1. Enter program mode. (See Section 5.1.)
1
2. Press for general options.
3
3. Press for communications.
5
4. Press to set up automation configuration.
5. Press until the ack time field is flashing.
6. From the number keypad enter the desired number or press the
flashes on the desired setting.
ENTER
7. Press .
MENU
8. If you wish to exit, press
ITI Options (Only Visible if ITI Gen or ITIComp Formats are Chosen)
These are options particular to the ITI automation format and can only be edited if one of these formats is
used to communicate with the automation computer. See Sections 8.8 and 8.10.
Follow these steps to set the ITI options:
1. Enter program mode. (See Section 5.1.)
2. Press 1 for general options.
3
3. Press for communications.
5
4. Press to set up automation configuration.
5. Press until the ack <ITI> field is flashing.
ENTER
6. Press .
MENU
Option Choices
Log Recs Y (Yes)
until you exit this menu.
until you exit this menu.
Table 5–7: ITI Automation Format Options
Default
N Log records identify the time and date of an incoming
report.
Section 5 – Programming
or button until the display
or button until the display
Meaning Comments
5–19