Copy Device(S) - Honeywell ADEMCO MX8000 Installation And Operation Manual

4. Press the or
5. When the desired setting is flashing press
6. To exit press .
5.4.3

Copy Device(s)

Copy Device(s) allows you to either program a line to defaults or copy the programming of an existing line.
5.4.3.1 To Program the Default Settings Into a Device
1. Enter Program Mode (see section 5.1).
2
2. Press for Line Device menu.
1
3. Press (MX8000–LC3) to select your line card type.
3
4. Press for copy Line Device menu.
5. Press the or
11 for description.
ENTER
6. Press .
MENU
7. Press the or
8. Press the or
this device back to default.
When all the device numbers (of the devices you wish to program to factory defaults) are chosen.
Warning: The following step cannot be undone.
9. Press .
5.4.3.2 Copy the Programming of an Existing Device to Another
1. Enter Program Mode (see section 5.1).
2. Press 2 for Line Device menu.
1
3. Press (MX8000–LC3) to select your line card type.
3
4. Press for copy Line Device menu.
5. Press the or
for description.
ENTER
6. Press .
MENU
button to change the Ringer Impedance.
button until the equal sign is adjacent to the Use Defaults option. See Table 5–
button until the equal sign highlights the desired Device number.
ENTER
button to toggle between Y (yes) or N (no). Yes means you wish to program
MENU
button until the equal sign is adjacent the Copy Existing option. See Table 5–11
ENTER
.
MENU
Section 5 – Programming
5–49