Honeywell ADEMCO MX8000 Installation And Operation Manual page 90

MX8000-3EX Installation and Operation Guide
5. When the desired wait time is flashing press
To Change the Acknowledgment Tone Duration Time:
The acknowledgment tone duration time is the amount of time the receiver will send an acknowledgment
tone to the reporting panel. See Table 5–11 for valid entries.
1. Follow the procedures in Section 5.4.2.
1
2. Press for handshake sequence menu.
3. Press until the display flashes on the AckDur field.
4. Enter the desired value from the keypad or press the
ment tone duration time.
5.4.2.2 Pulse Format
Select how this line card will handle pulse formats that are outside the standards for pulse format protocol.
To Select Which Format a 5-digit Pulse Format will be received as:
1. Follow the procedures in Section 5.4.2.
2
2. Press for pulse format menu.
3. When the display flashes on the 5-digit Fmt field.
4. Select the format by pressing the
5. When the desired wait time is flashing press
To Select Which Format a 6-digit Pulse Format will be received as:
1. Follow the procedures in Section 5.4.2.
2
2. Press for pulse format menu.
3. Press until the display flashes on the 6-digit Pulse Fmt field.
4. Select the format by pressing the
5. When the desired wait time is flashing press
To Select the Inter-Digit Time:
This option adjusts the time period between data blocks that the receiver will tolerate.
1. Follow the procedures in Section 5.4.2.
2
2. Press for pulse format menu.
3. Press until the display flashes on the Timeout field.
Note: When the Timeout field is set to 0 (recommended), the MX8000–3EX uses an algorithm to determine
the inter-digit time. When set between 1 ms and 2000 ms, the time entered will be used.
4. Enter the desired value from the keypad or press the
5–36
ENTER
or .
MENU
or
or button.
ENTER
or .
MENU
or button.
ENTER
or .
MENU
or
button to change the acknowledg-
button.