Table 5-13: Valid Programmable String Characters - Honeywell ADEMCO MX8000 Installation And Operation Manual

MX8000-3EX Installation and Operation Guide
F
P
,
H
@
t
0-9, *, #, A, B, C, D
6. Press to move to the next character.
or
ENTER
7. Press to enter the PBX string.
MENU
8. Select Y or N by pressing the
Y = Yes, erase or clear the PBX string. N = No, do not clear the PBX string, save the entered value.
Note: If Yes is selected the PBX string will be cleared and the "Clear String" option will revert to N (No).
To Change the Listen-In Timeout:
Timeout is the amount of time Listen-in will remain active before timing out.
Note: This setting will only have an affect if using the common mode. When using the PBX mode, the call is
transferred to another number and the line card drops the call.
1. Follow the procedures in Section 5.4.2.
2. Press 4 for Listen In options menu.
3. Press until the display flashes on the <Timeout> field.
4. Enter the desired value from the keypad or press the
setting. Values range from 0 to 255 in 1 second increments.
5. When the desired value is flashing press
To Edit the Listen-In Accounts Lists:
Note: The accounts lists apply to panels that do not send listen-in commands as a part of their message
(Contact ID E606 or SIA LF and LE). Panels that send listen-in commands as part of their message do not
need their account number in an account list.
1. Follow the procedures in Section 5.4.2.
4
2. Press for Listen In options menu.
3. Press until the display flashes on the <Account List> field.
ENTER
4. Press .
MENU
5–40
Table 5–13: Valid Programmable String Characters
Character
Flash hook.
Delay 500ms
Delay 2 seconds
Force a hang up of the line.
Detect dial tone.
Check to see if the line is busy by looking for a busy tone.
DTMF digits.
or
Description
arrows.
or
ENTER
.
MENU
button to change the timeout