Section 5 Programming; How To Enter Program Mode; Programming Fields; How To Maneuver Around In Program Mode - Honeywell ADEMCO MX8000 Installation And Operation Manual

Section 5 Programming

This section lists the programmable features in programming mode and the procedures for each of them. The
options available are general options, line card options, and user options.
After you complete your programming of the receiver, it is recommended that you make a
printout of the programmed values for reference. To make a printout of the programmed values,
see "How to Print System Configuration" on page 4–13 and perform a Print All operation.
5.1

How to Enter Program Mode

Follow these steps to enter into program mode:
1. Log on to the receiver (see Section 4.4.4 for log on procedure).
ENTER
2. Press the
MENU
7
3. Press the button.
4. Select the option you wish to program. (See Section 5.2 for options.)
5.1.1

Programming Fields

In program mode there are three types of programming fields that data can be entered into. Table 5–1 list
the three types of fields and the various parameters associated with them.
Type of Field
5.1.2

How to Maneuver Around in Program Mode

Figure 5–1 shows what keys on the touchpad are used to maneuver in program mode.
button.
Table 5–1: Types of Programming Fields
Control Keys
Numeric
0
through
or
List
Edit
0
through
or
NOTE
Comments
These fields require a numeric entry
9
only.
keys
Predefined choices are put in a list
and can be selected by pressing the
keys
up or down arrow keys.
Enter a number from the numeric
9
keypad or enter any special
characters by pressing the up or
down arrow keys.
keys
5–1