Table of Contents
Advertisement
5.4.2.7
Line Gain Opt.
This selection is used to select the gain for transmit and
receive for a line.
How to Set Transmit Gain
1. Follow the procedures in Section 5.4.2.
7
2. Press
for Line Gain Opt. menu (see Figure 5–21).
The display Flashes on the Xmit= field.
3. Press the
or
gain.
4. When the desired setting is flashing press
How to Set Receive Line Gain
1. Follow the procedures in Section 5.4.2.
7
2. Press
for Line Gain Opt. menu (see Figure 5–21).
3. Press the
button.
The display Flashes on the Rec= field.
4. Press the
or
5. When the desired setting is flashing press
6. To exit press
.
How to Set CID Monitor
Caller ID Monitor allows the selection of different modes for decoding Caller ID. These are:
•
Normal (or standard) where the detection method is first ring, delay, preamble, marks, and then Caller
ID data.
•
Preamble where the Caller ID chip looks for preamble data prior to Caller ID.
•
DTMF where the system looks for DTMF based Caller ID data. (This is a non-standard method of Caller
ID.
•
Marks where the Caller ID chip looks for a Marks signal prior to the Caller ID data.
Note: This option is will only be applicable when Caller ID has been selected.
1. Follow the procedures in Section 5.4.2.
7
2. Press
for Line Gain Opt. menu (see Figure 5–21).
3. Press the
The display Flashes on the Mon= field.
4. Press the
or
5. When the desired setting is flashing press
button to change the transmit
button to change the receive gain.
.
button to change the CID monitor.
<Edit Line :01>
7 Line Gain Opt.
< Exit Menu
Xmit=-8db
Mon=Norm Gain=2.0db
OHGain=7.0db RImp=HI
<TransmitGain<=Exit>
Figure 5–21: MX8000–LC3 Line Gain Options
ENTER
.
MENU
ENTER
.
MENU
ENTER
.
MENU
Section 5 – Programming
Rec=6db
5–47
Advertisement
Table of Contents
Troubleshooting
