Clear Device; View Devices; Figure 5-22: Visual Steps To Clear A Line From The Receiver - Honeywell ADEMCO MX8000 Installation And Operation Manual

MX8000-3EX Installation and Operation Guide
7. Press the or
ENTER
8. Press .
MENU
9. Press the or
10. Press the or
this line device with the programming of the line device chosen as the source.
11. Repeat steps 8 & 9 until all the line card numbers (of the Lines you wish to program to factory defaults)
are chosen.
Warning: The following step cannot be undone.
12. Press .
5.4.4

Clear Device

To Clear or Delete a Device From the Receiver Follow These Steps:
1. Enter Program Mode (see section 5.1).
2
2. Press for Line Device menu.
1
3. Press (MX8000–LC3) to select your line card type.
4
4. Press to clear a Device.
5. When display shows the list of Devices (see Figure 5–22)
press the until the desired Line is highlighted with
an equal sign.
Note: The MX8000–LC3 shown in Figure 5–22 is an
example only. The display will contain the number of the
line card you are clearing.
ENTER
6. Press .
MENU
The display will read
7. Press the until Yes is flashing.
ENTER
8. Press .
MENU
9. To exit press .
5.4.5

View Devices

To view all the Lines in the receiver follow these steps:
1. Enter Program Mode (see section 5.1).
2
2. Press for Line Device menu.
5–50
button until the equal sign highlights the desired Source Device number.
button until the equal sign highlights the desired Target Device number.
ENTER
button to toggle between Y (yes) and N (no). Yes means you wish to program
MENU
<Warning!>
LC01 MX8000–LC3
Delete Record No
<Clear Device>
D01=MX8000-LC3
D02 MX8000-LC3
D03 MX8000-LC3
< WARNING! >
LC01 MX8000-LC3
Delete Record No
Figure 5–22: Visual Steps to Clear a Line
From the Receiver
ENTER
¯
MENU