Flywheel And Drive Plate; Gonnecting Rod And Crankshaft; End Play; Replacement - Honda Prelude 1993 Service Manual

Gonnecting Rod and
Connecting Rod End Plsy:
Standard (Newl: 0.15 - 0.30 mm
{0.006 - 0.012 in)
Sorvice Limit 0.40 mm 10.016 inl
CONNECTING ROO
. lf out-of-tolerance, install a new connecting rod.
. lf still out-of-tolerance, replace the crankshaft lpages
7-11 and 7-26]..
Push the crankshaft firmly away from the dial indicstor.
and zero the dial against the end of the crsnkshaft. Then
pull the crankshaft firmly back toward the indicator; dial
reading should not exceed service limit.
Crankshaft End Phy:
Standard lNqwl: 0.10 - 0.35 mm
(0.004 - 0.014 in)
Ssrvice Limit
0.45 mm {0.018 inl
. lf end play is excessive than the service limit, inspect
the thrust washers and thrust surface on the crank,
shaft. Replace parts as necessary.
NOTE: Thrust washer thickness is fixed and must not be
changed either by grinding or shimming.
Thrust washers are installed with grooved sides facing
outwaad.
Flywheel and Drive Plate
Crankshaft
Replacement
End Play
Manual Transmission:
Remove the eight flywheel bolts, then separate the fly-
w h e e l f r o m t h e c r a n k s h a f t f l a n g e . A f t e r i n s t a l l a t i o n ,
tighten the bolts in the sequence shown.
RING GEAi
07LAB - PVtDl(x)
or 0792it - PO20O03
BING GEAR HOLDER
07LAB - Pv(xrltx)
or 07924 - PD2qr03
Inspgct ring gear
teoth for w6ar or damage.
12 x 1.0 mm
105 N.rn 110.5 kg-m, tG lb-ft,
Automatic Transmission:
Remove the €ight drive plate bolts, thon separate the
drive plate from the crankshaft flange. After installation.
tighten the bolts in the sequence shown.
a o o
\ o ;
SCREWDRIVER
/ AXid-*a\Ao
7- 7