Shift Control Solenoid Valve A/B - Honda Prelude 1993 Service Manual

Shift Control Solenoid Valve A/B
NOTE:
Shift control solenoid valves A and B must be remov€d/
reolaced as an assemblv.
1. Disconnect the connector from the shiJt control
solenoid vave A/8.
2. M€asure the resistance between the No. 1 terminal
(solenoid valve A) of the shitt control solenoid valve
connactor and body ground, snd between the No. 2
terminal (solenoid valve B) and body ground.
STANDARD: 12- 24Q
Replace the shfft control solenoid valve assembty if
th€ r€sistance is out of soecification.
lf the resistsnce is within the standard, connsct the
No. 1 terminal of the shift control solenoid valve
connector to the battery positive terminsl. A clicking
sound should be heard. Connect the No, 2 terminal to
the battery poshive terminsl. A clicking sound should
be he8rd. Replace the shiJt control solenoid valve
assembly if no clicking sound is hesrd,
Replacement
1. Remove the mounting bohs and shift control solenoid
vafue assamblv.
NOTE:
Be sure to remove or replace the shift control solenoid
valves A and B as an assembly.
2.
Check the shift control solenoid vatue oil passages for
dust or dirt, and replace as an assembly, if necesssry.
6 x 1 . O m m
12 N.m 11.2 kg"m , 9 lb-ft)
Cl6an the mounting surfac6
and oilpass€gBs.
FILTER/GASKET
R6placs.
sHtFT COI{fROL
SOLENOID VALVE
ASSEMBLY
3.
Clean the mounting su ace and oil passages of the
shift control solenoid valve assembly, and install a new
fiher/gasket,
4. Chsck the connector for rust, dirt or oil, and recon-
nect it securely.
1 4- 63