Rear Caliper Reassembly - Honda Prelude 1993 Service Manual

Rear Caliper
Reassembly
CAUTION:
a Do not spill brakotluidonthe car; it may damago the
paint; if blake fluid does contact the paint, wash it
oft immsdiatoly with water.
a Botore reassembling, check thst all pa.ts aro floa ol
dust and oth€r forsign panicles.
a Roplace parts with new ones when€ve. sp€cifisd to
do ao.
a Make sure no din or other for€ign matter is allowed
to contaminato the brak€ tluid.
a Oo not mix different brands of brske fluid as thoy
may not be compatibl€.
a Do not reuse th€ drained tluid, Uso only cloan DOT 3
or 4 brake fluid.
'I . Pack
all cavities of the needle bearing with com-
mercially available assembly lube.
2. Coat the new cam boot with commercially
available assembly lube and install it in the caliper
D O O y .
3. Apply commercially available assembly lube to the
pin contacting area of the cam and install the cam
and lever assembly into the caliper body.
4. Install the return spring.
CAUTION:
a When the cam and leve? wa.e separatgd, bo
sure to assemblo thsm betoro installing the cam
in th€ caliper body. Install tho l€vsr and 3p ng
washer, apply locking ag€nt to ths threads, and
tighten the parking nut whib holding lhe lovor
with a viso.
a Avoid damaging the cam boot since it must be
installed botore the cam.
a When installing the cam, do not allow the cam
boot liDs to tu]n outsid€ in.
19-24
Z^"
: Commarcially .vailabl€
#jlqqil
..'embtv tube
RETURN
lnstsll the pin in the cam.
Install a new O-ring on the sleeve piston.
lnstall the sleeve Diston so the hole in the bottom of
the piston is aligned with the pin in the cam, and
two pins on the piston are aligned with the holes in
the caliDer.
SLEEV€ nSTOf{
HOLES