Wheel Measurements; Bearing End Play; Runout - Honda Prelude 1993 Service Manual

Wheel Measurements
Bearing End Play
1 .
Raise the car and support it with safety stands in the
proper locations (see section 1,.
2. Remove the wheels, then reinstall the lug nuts.
3. Attach the dial gauge as shown.
4.
M€asure the bearing end play by moving the disc in
and out.
front wheol End Play:
Standard: 0-O.O5 mm {O-O.002 inl
Rear Who6l End PlsY:
Standard: 0-0.05 mm (0-0.002 in)
lf the bearing end play measurement is more than
the standard, replace the wheel bearing.
Runout
1 . Raise the car and support it with safety stands in the
proper locations (see section I l.
2. Check tor b€nt or deformed wheels.
3. Attach the dial gauge as shown.
4.
Measure the wheel runout by tuming the wheel.
Front and Raar Wheel Axial Runout:
Standard:
St6ol l|haol:
0- 1 .O mm (O-O.O4 in)
Aluminum Whool: O-O.7 mm {0-0.03 in}
Se.vlce Limitr
2.O mm {0.O8 inl
Front and Rear Wheel Radial Runout:
St.ndard;
Stoel Whool:
0-1.0 mm (O-O'O4 inl
Aluminum Wh.ol: O-O'7 mm (O-O.O3 inl
Scrvico Limlt:
1.5 mm (0.06 inl
lf the wheel runout is more than the service limn
reolace the wheel.
1&9