Motor, Drain Tube, And Flame Replacement - Honda Prelude 1993 Service Manual

REAR T()OK (2}
FRAMC SEAL
I x 1.O n||n
10 N'm (1o kgFm .
7 b-ft)
NOTE:
MOTOR
M6ko su.o th€ lft6.s 6re
pal.l6l when instarng th6
motor.
lf you n6ed to remov6 a drain
tubo, tie a string to th6 ond ot
it so h can bs roinstall€d.
REAR DRAIN TUBE
/-:\
\g
@
Sunroof
Motor, Drain Tube, and Flame Replacement
cAuTto :
Be c'rfirl ]pl to damago th€ soats or oth6l intorlor trim.
1. Rornove the headliner (see page 2G36).
2.
Disconnect the motor connector; remova the clips securing the ceiling light wire harness'
NOTE:
When removing the motor, remove the two mounting bohs and three nuts.
3. Remove the sunrool panel(see page 2G31).
4.
Disconnect the drain tubes.
5.
Remove the 10 mounting bolts and rear hooks, then remove the frame from the car'
NOTE:
You mav require assistance when removing the lrame.
DRAhI TUBE
To instsl, sid6 ths drsin tubs ovor th€
trsrns nozzl€ st loast 10 mm (0.4 in).
DRAI TUBE
GUIDE PIiI
To install, ins€rt ths Jrama's fear hooks into th€ body hol€s, then install parts in the reverse order of removal.
NOTE:
. Install rhe tube clips with the 6nds facing to the side to esse instsllstion of the headliner.
. Clean the surface ol frame.
. Check the frame seal.
. Check tor wster leaks.
FRAME
FRONT DRAIN TUBE
20-32