Steering Pump Replacement; Pulley Replacement - Honda Prelude 1993 Service Manual

Steering Pump
Replacement
NOTE: Before disconnecting the hoses from the pump,
place a suitable container under the car.
1. Orain the tluid from the system (see page 17-77).
2.
Remove the belt by loosening the power steering
mounting bolt, nut and adjusting bolt
3.
Disconnect the inlet and outlet hoses from the
pump and plug them.
NOTE: Take care not to spill the fluid on the body
and parts. Wipe oft the spilled at once
4.
Remove the power steering mounting bolt and nut,
then remove the pumP.
ADJUSTING
o9llEr eolr
BOLT
't 't N.m
11.1 kg-m, 8 lb-ft)
PUMP ASSEMBLY
HOSE CLAMP
STEERING
MOUNTING NUTS
2 2 N . m
12.2 kg-m, 16 lb-ftl
INLET HOSE
POWER STEERING BELT
PULLEY
POW€R
MOUNTING BOLT
22 N.m
(2.2 ks-m. 16 lb'ft)
NOTE: Do not turn the steering wheel while the
pump removeo.
5. Loosely install a new pump on the bracket.
6.
Connect the inlet and outlet hoses to the pump.
7.
lnstall and adiust the belt (see page 17-741.
CAUTION:
a Mak€ sure that the powel steering belt is
securoly on the groove of tho pulleys
a Do not get powor ste€ring fluid or groase in the
powsr steeiing belt or pulley {aces.
Cl€an ofl any fluid or gloase bsforo installation.
8.
Fill rhe reservoir with new fluid to the UPPER level
fine on the reservoir {see page 17 -771
Pulley Replacement
Hold the steering pump in a vise with soft jaws, and
hold the pulleY with the special tool, and remove the
p u l l e y n u t a n d P u l l e Y
N O T E : P u l l e y n u t h a s l e l t - h a n d t h r e a d s .
UNIVERSAL
HOLDER
07725-O030000
PULLEY NUT
Left-hand thread
Reinstall the pulley in the reverse order ol removal
NOTE: Install the pulley as shown
PULLEY NUT
6 5 N ' m ( 6 . 5 k g - m , 4 7 l b - f t )
O.RING
Replace.
Check
pulley.
1 7 - 96
that the pump turns smoothly by turning the