Honda Prelude 1993 Service Manual page 821

Front Suspension
Knuckle/Hub (cont'd)
8
41. Install the wheel sensor with the sensor mounting
bolts.
NOTE:8e careful when installing the sensors to
avoid lwisting wires.
44. Install the brake caliper with the calipel bracket
mounting bolts.
45. Install the brake hose with the brake hose mounting
bolts.
BRAKE HOSE
MOUNTING BOLTS
lo N'm (t.o kg-m, 7 lb-ft1
42. lnstall the sensor wire with the two bolts.
10 N.m
SENSOR MOUNTING
BOLTS
22 N.Jn
12.2 ks-m, 16 lb-ft)
( 1 . O 7 tb-fr)
WHEEL SENSOR
'l '10 N.m (1 1 kg-m. 80 lb-ftl
46. Tighten the new spindle nut.
NOT€: Betore installing the wheel, clean the mating
surlace of the brake disc and inside ot the wheel.
47. Install the wheel with the wheel lug nuts.
43.
lnstall the brake disc with the 6 mm brake disc re-
taining screws.
WHEEL LUG NUT
1 2 x 1 . 5 m m
t 1 0 . i n
{11 kg-m. 80 lb-fr}
6 mm BRAKE DISC
RETAII{II{G SCREWS
10 N.m ll.0 kg-m,7 tb-fr)
24 x 1.5 mm
250
'm {25 kg-m, 181 lb'ftl
NOTE: After tightening, use a drift
to stake sDindle nut shoulder
against the spindle.
Check the front wheel alignment and adjust if neces-
sary (see page 18-41.
44.
8 - 1