Bearing Replacement; Backlash Inspection - Honda Prelude 1993 Service Manual

' t . P l a c e t h e d i f f e r e n t i a l a s s e m b l y o n V - b l o c k s
install both axles.
Check backlash of both side gears.
Standard lNowl: 0.05 - 0.15 mm
10.002 - 0.006 in.l
3. lf out of tolerance, disassemble the differential and
select new pinion washers from the table below.
PINION WASHEB
DIALINDICATOR SIDEGEARS
Part Numbcr Thickness
4 1 3 5 1 - P G I - 0 0 0
4 1 3 5 2 - P G 1 - 0 0 0
4 1 3 5 3 - P G 1 - 0 0 0
4 1 3 5 4 * P G 1 - 0 0 0
4 1 3 5 5 - P G 1 - 0 0 0
4 1 3 5 6 - P G l - 0 0 0
4 1 3 5 7 - P G 1 - 0 0 0
4 1 3 5 8 - P G 1 - 0 0 0
0.70 mm (0.028
0.75 mm (0.029
0.80 mm (0.031
0.85 mm (0.032
0.90 mm (0.035
0.95 mm (0.036
1.00 mm (0.039
1.05 mm (0.041
n )
n )
n )
n )
n )
n )
n )
n )
Differential (Automatic Transmissionl
Backlash Inspection
Bearing Replacement
NOTE: Check the bearings for wear and rough rotation.
lf the bearings are OK, removal is not necessary.
Remove the taper
p u I e r .
r o l l e r b e a r i n g s u s i n g a b e a r i n g
BEARING PULI.IR
TAPER ROLLER BEARING
Install the new taper roller bearings. using the spe-
cialtool and a press as shown,
NOTE:
.
Drive the bearings on until they bottom.
. Use the special tool:
.
large end for torque converter housing side
bearing.
small end for transmission housing side bear-
Ing.
ATTACHMENT,
,(t x 50 mm
07LAD - PW5o601
NOTE:
. The bearing and outer race should be replaced
as a set.
. lnspect and adjust the bearing preload whenever
a bearing is replaced.
. Drive in the bearings securely so that there is no
clearance between the bearings and differential
carner.
15-14