Settings For Tool Lists - Siemens SINUMERIK 828D Operating Manual

Tool management

12.14 Settings for tool lists

12.14 Settings for tool lists
In the "Settings" window you have the following options to set the view in the tool lists:
● Display only one magazine in "Magazine sort"
– You can limit the display to one magazine. The magazine is displayed with the
– You may set via a configuration if you want to jump to the next magazine by clicking
● Display only spindle in buffer.
In order to display only the spindle location during operation, the remaining locations of
the buffer are hidden.
● Permitting tool in/out file
– When creating a new tool, the tool data can be loaded from a file.
– When deleting or unloading a tool, the tool data can be backed up to a file.
● Switch on adapter-transformed view
– Geometry lengths and the application offsets are displayed in a transformed manner in
– In the tool wear list, the wear length and the sum offsets are displayed in a
References
For further information about configuring the settings, please refer to the following
references:
SINUMERIK Operate (IM9) / SINUMERIK 840D sl Commissioning Manual
718
assigned buffer magazine locations and the tools not loaded.
softkey "Magazine selection" or if the dialog "Magazine selection" is switched over to
any magazine.
the tool list.
transformed manner.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Turning