Starting The Mold Making View - Siemens SINUMERIK 828D Operating Manual

5.13.2

Starting the mold making view

Procedure
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
1. Select the "Program manager" operating area.
2. Select the desired storage location and position the cursor on the pro-
gram that you would like to display in the mold making view.
3. Press the "Open" softkey.
The program is opened in the editor.
4. Press the ">>" and "Mold making view" softkeys.
The editor splits up into two areas.
The G code blocks are displayed in the left half of the editor.
The workpiece graphic is displayed in the right half of the editor.
All of the points and paths programmed in the part program are shown
in the graphical representation.
5. Press softkey "Lines G1" or "Lines G0", to hide the corresponding line
elements of the graphic.
- OR -
Press softkey "Hide points" to hide the points of the graphic.
Note:
You have the option of simultaneously hiding G1 and G0 lines.
In this case softkey "Hide points" is deactivated.
6. Press the "Graphic" softkey in order to hide the graphic and to view the
program as usual in the editor
- OR -
Press the "NC blocks" softkey in order to hide the G code blocks and
therefore only to display the graphic.
Machining the workpiece
5.13 Mold making view
173