Parameters
Complete transfer
function
Withdraw blank
F
Cutting-off
cycle
Complete transfer
function
Work offset
Write to the
work offset
ZV - only for
work offset
write "yes"
Z4W
Complete transfer
function
Work offset
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Description
Withdrawing
Withdraw complete blank:
Yes
•
No
•
Feed (only when "yes" for "withdraw blank")
Cutting-off cycle in the following block
Yes
•
No
•
Rear side (for main spindle in counter-spindle)
Work offset in which the coordinate system, which was shifted according to ZW
and by ZV as well as mirrored in Z, must be saved:
Basic reference
•
G54
•
G55
•
G56
•
G57
•
...
•
Yes
•
The Z value of the work offset can be directly written to the input screen
form.
No
•
The actual Z value of the work offset is used.
Offset Z = 0 (abs)
•
Workpiece zero is offset in Z direction (inc, the sign is also evaluated)
•
Supplementary axis of the counter-spindle machining position (abs); MCS
Front side (for counter-spindle in main spindle)
Work offset in which the coordinate system, which was shifted according to ZP
and by ZV as well as mirrored in Z, must be saved:
Basic reference
G54
G55
G56
G57
...
Multi-channel machining
10.2 Multi-channel support
Unit
mm/min
mm
mm
661