Editing A Program - Siemens SINUMERIK 828D Operating Manual

Machining the workpiece

5.10 Editing a program

5.10 Editing a program
With the editor, you are able to render, supplement, or change part programs.
Note
Maximum block length
The maximum block length is 512 characters.
Calling the editor
● The editor is started via the "Program correction" softkey in the "Machine" operating area.
You can directly change the program by pressing the <INSERT> key.
● The editor is called via the "Open" softkey as well as with the <INPUT> or <Cursor right>
key in the "Program manager" operating area.
● The editor opens in the "Program" operating area with the last executed part program, if
this was not explicitly exited via the "Close" softkey.
Note
• Please note that the changes to programs saved in the NC memory take immediate
• If you are editing on a local drive or external drives, you can also exit the editor without
• Exit the program correction mode using the "Close" softkey to return to the "Program
See also
Editor settings (Page 153)
Correcting a program (Page 129)
Opening and closing the program (Page 738)
Generating a G code program (Page 221)
144
effect.
saving, depending on the setting. Programs in the NC memory are always
automatically saved.
manager" operating area.
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Turning