Siemens SINUMERIK 828D Operating Manual page 278

Creating a ShopTurn program
8.18 Example: Standard machining
5. Stock removal (roughing)
278
1. Press the "Cont. turn." and "Stock removal" softkeys.
The "Stock Removal" input window opens.
2. Enter the following technology parameters:
T Roughing tool 80 D1
3. Enter the following parameters:
Machining
Machining direction
Position
Machining direction
D 4.000 inc
Cutting depth
UX 0.4 inc
UZ 0.2 inc
DI
BL Cylinder
XD
ZD
Relief cuts
Set machining
area limits
4. Press the "Accept" softkey.
If a blank programmed under "CONT_1" is used, under parameter "BL",
the "Contour" blank description should be selected instead of "Cylinder".
When selecting "Cylinder", the workpiece is cut from the solid material.
F 0.350 mm/rev
Roughing (∇)
Longitudinal
outside
(from the face to the rear side)
0
0 inc
0 inc
No
No
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
V 400 m/min
Turning