Engraving (Cycle60) - Siemens SINUMERIK 828D Operating Manual

Parameter
P
- (selection
option only for table
selection "without")
∅
H1
DXY
rev
αS
9.4.12

Engraving (CYCLE60)

Function
The "Engraving" function is used to engrave a text on a workpiece along a line or arc.
You can enter the text directly in the text field as "fixed text" or assign it via a variable as
"variable text".
Engraving uses a proportional font, i.e., the individual characters are of different widths.
Approach/retraction
1. The tool approaches the starting point at rapid traverse at the height of the retraction
plane and adjusts to the safety clearance.
2. The tool moves to the machining depth FZ at the infeed feedrate Z1 and mills the
characters.
3. The tool retracts to the safety clearance at rapid traverse and moves along a straight line
to the next character.
4. Steps 2 and 3 are repeated until the entire text has been milled.
5. The tool moves to the retraction plane in rapid traverse.
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Description
Pitch ...
In MODULUS: For example, generally used for worm gears that mesh with a
•
gear wheel.
Per inch: Used with pipe threads, for example.
•
When entered per inch, enter the integer number in front of the decimal point
in the first parameter field and the figures after the decimal point as a fraction
in the second and third field.
In mm/rev
•
In inch/rev
•
The tool used depends on the thread pitch.
Nominal diameter
Example: Nominal diameter of M12 = 12 mm
Thread depth
Maximum plane infeed
Finishing allowance in X and Y - (only for ∇)
Starting angle
Programming technology functions (cycles)
9.4 Milling
Unit
MODULUS
Turns/"
mm/rev
in/rev
mm
mm
mm
mm
Degrees
507