Siemens SINUMERIK 828D Operating Manual page 33

Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
<CTRL> + <P>
Generates a screenshot from the actual user interface and
saves it as file.
<CTRL> + <S>
Switches the single block in or out in the simulation.
<CTRL> + <V>
• Pastes text from the clipboard at the actual cursor position.
• Pastes text from the clipboard at the position of a selected
text.
<CTRL> + <X>
Cuts out the selected text. The text is located in the clipboard.
<CTRL> + <Y>
Reactivates changes that were undone (only in the program
editor).
<CTRL> + <Z>
Undoes the last action (only in the program editor).
<CTRL> + <ALT> + <C>
Creates a complete standard archive (.ARC) on an external
data carrier (USB-FlashDrive) (for 840D sl / 828D).
Note:
The complete backup via this key combination is only suitable
for diagnostic purposes.
Note:
Please refer to the machine manufacturer's specifications.
<CTRL> + <ALT> + <S>
Creates a complete standard archive (.ARC) on an external
data carrier (USB-FlashDrive) (for 840D sl).
Creates a complete Easy Archive (.ARD) on an external data
carrier (USB-FlashDrive) (for 828D).
Note:
The complete backup (.ARC) via this key combination is only
suitable for diagnostic purposes.
Note:
Please refer to the machine manufacturer's specifications.
<CTRL> + <ALT> + <D>
Backs up the log files on the USB-FlashDrive. If a USB-
FlashDrive is not inserted, then the files are backed-up in the
manufacturer's area of the CF card.
Introduction
2.2 Operator panel fronts
33