Siemens SINUMERIK 828D Operating Manual page 480

Programming technology functions (cycles)
9.4 Milling
Parameter
X0
Y0
Z0
(only for G code)
X0 or L0
Y0 or C0
Z0
(only for ShopTurn)
CP
X0 or L0
Y0 or C0
Z0
(only for ShopTurn)
Y0 or C0
Z0
X0
(only for ShopTurn)
C0
Y0
Z0
X0
(only for ShopTurn)
W
L
Z1
DXY
(only for ShopTurn)
DZ
UXY
UZ
480
Description
The positions refer to the reference point:
Reference point X
Reference point Y
Reference point Z
Face C: The positions refer to the reference point:
Reference point X or reference point length polar
Reference point Y or reference point angle polar
Reference point Z
Face Y: The positions refer to the reference point:
Positioning angle for machining area
Reference point X or reference point length polar
Reference point Y or reference point angle polar
Reference point Z
Peripheral surface C: The positions refer to the reference point:
Reference point Y or reference point angle polar
Reference point Z
Cylinder diameter ∅
Peripheral surface Y: The positions refer to the reference point:
Positioning angle for machining surface
Reference point Y
Reference point Z
Reference point X
Slot width
Slot length
Slot depth (abs) or depth referred to Z0 or X0 (inc) - (only for ∇ and ∇∇∇)
Maximum plane infeed
•
Maximum plane infeed as a percentage of the milling cutter diameter
•
- (only for ∇ and ∇∇∇)
Maximum depth infeed – (only for ∇ and ∇∇∇)
Plane finishing allowance for the length (L) and width (W) of the slot (only for ∇
and ∇∇∇).
Depth finishing allowance (tool axis) - (only for ∇ and ∇∇∇)
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
mm
mm
mm
mm
mm or
degrees
mm
Degrees
mm
mm or
degrees
mm
mm or
degrees
mm
mm
Degrees
mm
mm
mm
mm
mm
mm
mm
%
mm
mm
mm
Turning