Cutting Edge Data - Siemens SINUMERIK 828D Operating Manual

12.9.3

Cutting edge data

The "Tool Details" window provides the following data on the selected tool when the "Cutting
edge data" softkey is active.
Parameter
Magazine location
Tool name
ST
D quantity
D
Tool type
Geometry
Wear
Geometry
Wear
For type 500 (rougher) and type 510 (finisher)
Cutting edge graphic
Reference direction
Holder angle
Cutting tip angle
Type 240 - tap
Pitch
Type 200 - twist drill, type 220 - centering tool and type 230 - countersink
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Meaning
The magazine number is specified first, followed by the location number in the maga-
zine.
If there is only one magazine, only the location number is displayed.
The tool is identified by the name and the sister tool number. You can enter the name
as text or number.
Sister tool number (for replacement tool strategy)
Number of created cutting edges
Cutting edge number
Tool symbol with type number and current cutting edge position
Length X Length Z
Geometry data, length Geometry data, length Z
X
Length X wear Length Y wear
Radius
Tool radius
Radius wear
The cutting edge graphic shows the positioning defined by
the holder angle, cut direction and cutting tip angle.
The reference direction for the holder angle specifies the cut
direction.
To determine the cutting edge positioning
To determine the cutting edge positioning
Tool management
12.9 Tool details
709