Stock Removal - Siemens SINUMERIK 828D Operating Manual

Multi-channel machining
10.2 Multi-channel support
10.2.13.2

Stock removal

Calling up the cycle
Precondition
● "programSYNC" option
Procedure
Only those parameters relevant for stock removal with 2 synchronized channels of a
workpiece are subsequently described. All other parameters are described in Chapter
"Contour turning".
Parameters
Parameter Description
Machining
•
•
Channel Defines whether the currently set channel is the leading or following channel.
All calculations are carried out in the leading channel.
Number Selecting the number of the partner channel if there are more than 2 channels avail-
able.
•
•
DCH Channel offset
•
•
•
658
1. The part program or ShopTurn program to be processed has been cre-
ated and you are in the editor.
2. Press the "Contour turning" softkey.
3. Press the "Stock removal" softkey.
∇ 2 CHAN
2-channel roughing
∇∇∇ 2 CHAN
2-channel finishing
If, for the channel parameter, "Leading channel" is selected, then the channel
number of the following channel must be parameterized here.
If, for the channel parameter, "Following channel" is selected, then the channel
number of the leading channel must be parameterized here.
For positive parameters, then the leading channel machining is executed before
the following channel by the channel offset.
For a negative parameter, when executing the program, the leading or following
channel property is interchanged.
If the parameter is equal to zero, then balance cutting (axis coupling) is used.
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Unit
mm (inch)
Turning