Siemens SINUMERIK 828D Operating Manual page 452

Programming technology functions (cycles)
9.4 Milling
Parameter Description
Clamp/release spindle (only for end face Y/peripheral surface Y)
The function must be set up by the machine manufacturer.
(only for ShopTurn)
Machining
•
•
•
•
Machining type
•
•
The positions refer to the reference point:
X0 Reference point X
Y0 Reference point Y
Z0 Reference point Z
(only for G code)
Face C: The positions refer to the reference point:
X0 or L0 Reference point X or reference point length polar
Y0 or C0 Reference point Y or reference point angle polar
Z0 (only for Shop- Reference point Z
Turn)
Face Y: The positions refer to the reference point:
CP Positioning angle for machining area
X0 or L0 Reference point X or reference point length polar
Y0 or C0 Reference point Y or reference point angle polar
Z0 (only for Shop- Reference point Z
Turn)
Peripheral surface C: The positions refer to the reference point:
Y0 or C0 Reference point Y or reference point length polar
Z0 Reference point Z
X0 Cylinder diameter ∅
(only for ShopTurn)
Peripheral surface Y: The positions refer to the reference point:
C0 Positioning angle for machining surface
Y0 Reference point Y
Z0 Reference point Z
X0 Reference point X
(only for ShopTurn)
452
∇ (roughing)
∇∇∇ (finishing)
∇∇∇ edge (edge finishing, plane-by-plane or helical)
Chamfering
Plane by plane
Solid machine circular pocket plane-by-plane
Helical
Solid machine circular pocket helically
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
mm
mm
mm
mm
mm or
degrees
mm
Degrees
mm
mm or
degrees
mm
mm or de-
grees
mm
mm
Degrees
mm
mm
mm
Turning