Configuration And Operation - Bosch DCN Next Generation Installation And User Instructions Manual

DCN NG | Installation and User Instructions | Section 3 | Central Control Equipment
To navigate through the main menu:
1 Turn the button to move through the main menu
items. The item number and title start blinking.
(The first item, Unit Name, does not blink.)
To jump to a submenu:
1 Navigate in the main menu to an item with three
dots (e.g. Setup ...).
2 Push the button to go to the submenu. The submenu
item and title start blinking.
Note
To enter the Setup submenu, push and hold the
button for at least 3 seconds.
To navigate through a submenu:
1 Turn the button to move the cursor to the submenu
item character.
2 Push the button. The item character and title start
blinking.
3 Turn to select another submenu item character.
4 Push to confirm the selection.
To change option values:
1 Navigate to the applicable menu item.
2 Turn the button to move the cursor to the option
value you want to change.
3 Push the button to activate the option. The option
value starts to blink.
4 Turn the button to select a new option value.
5 Push the button to confirm the new value. The
option value stops blinking.
6 Turn the button to move the cursor to another
settable option (when available) and repeat
steps 3 to 5.
To jump back from a submenu to an item of
the main menu:
1 Turn the button to move the cursor to the main
menu item number.
2 Push the button. The item number starts blinking.
3 Turn to select another item number.
4 Push to confirm the selection.
Bosch Security Systems | 2004-03 | 9922 141 70521en
8.6

Configuration and operation

8.6.1 Introduction
The next sections give descriptions of the possible
configuration options. Each description is followed by
the relevant menu items with detailed information per
menu option. The default values are indicated by an
asterisk (*) when applicable.
8.6.2 Start-up
When the CCU is switched on, the display shows the
Unit Name screen, which is the first item of the main
menu. The display also goes to this screen after
3 minutes of inactivity.
Note
The CCU does not switch back to the start-up
screen after 3 minutes of inactivity in
submenu 1.
8.6.3 Main menu
The main menu contains the screens to show the unit
name and contains the entry points to the Monitoring,
Enquiry and Setup submenus.
table 8.7: Main menus
Menu Description
0 Unit Name Shows the name of the unit.
See section 8.6.4.
1 Monitoring Go to the Monitoring submenu.
See section 8.6.5.
2 Enquiry Go to the Enquiry submenu.
See section 8.6.6.
3 Setup Go to the Setup submenu.
See section 8.6.7 (and further).
8.6.4 View unit name
The first screen of the main menu shows the name of
the CCU. The default name is CCU.
en | 71