Bosch DCN Next Generation Installation And User Instructions Manual page 41

DCN NG | Installation and User Instructions | Section 2 | Interpretation Equipment
5.2.2 Top view
The top of the channel selector (see figure 5.2) contains
the following:
6 DCN cable - A 2 m long cable to connect the
channel selector to the system. The cable is
terminated with a moulded, male, 6-pole, circular
connector (see section 5.3.2).
7 DCN socket - A female, 6-pole, circular socket to
loop the channel selector through (see section 5.3.2).
8 Solder spots - Three solder spots to configure the
channel selector (see section 5.5).
9 Reduce output level - A 2-pin header connector
to reduce the output level of the channel selector.
(see section 5.3.5).
6 7
figure 5.2: Top view of the channel selector
Bosch Security Systems | 2004-03 | 9922 141 70521en
5.2.3
The rear of the channel selector (see figure 5.3) contains
the following:
10 Extra headphones connector - Three solder
pads to connect an extra headphones socket. These
solder pads are internally connected to a 3-pin
header (see section 5.2.1) that can be used for the
same purpose. See section 5.3.4 for information
about connecting an extra headphones socket.
figure 5.3: Rear view of the channel selector
X14
8 9
Rear view
10
en | 41