Pc Control; Requirements; Connecting To The Ccu; Connecting Peripheral Devices - Bosch DCN Next Generation Installation And User Instructions Manual

DCN NG | Installation and User Instructions | Section 6 | System Set-up and Operation
32

PC Control

32. 1

Requirements

The control PC must comply to the following
requirements:
Operating system:
Windows 2000
Windows XP Professional
Ethernet:
Ethernet for use in multi PC systems.
Serial ports (RS232):
Serial ports (RS232) for connection to CCU, label
printer, error logging, printing microphone activity.
Parallel port
Parallel printer port for connection to a printer.

32.2 Connecting to the CCU

By default, RS232 port 1 of the CCU is configured for
connection to a PC. See chapter 8 for information about
the configuration of the ports. Connect the PC to the
CCU using a RS232 wire-to-wire cable (see section
8.3.8)
Bosch Security Systems | 2004-03 | 9922 141 70521en
32.3 Connecting peripheral
devices
32.3.1 Overview
The next figure give an overview of the printer and
COM port settings of a Control PC.
LPT 1 (IRQ = 7)
Software module
LBB 4190 Start-up
LBB 4185 System
installation
LBB 4172 Simultaneous
interpretation
figure 32. 1 : PC port settings
The next table contains the default port settings for
COM 1 of a Control PC. The COM port settings can be
changed from the Windows Control Panel, whereas the
COM port assignments can be changed in the dcnng.ini
file (located in the Windows directory).
table 32. 1 : COM 1 default settings
Setting Value
Baudrate 9600
Data bits 8
Parity None
Flow control None
en | 151
Laser printer Matrix printer
COM 1 (IRQ = 4)
Windows print
= ASCII + CR + LF
manager
Error logging
Error messages
real-time
printing
sent to auxiliary
Seat numbers
printing
Channel
assignment
printing
Desk language
assignment
auto printing
Channel language
assignment
printing