Block-Mounting - Bosch DCN Next Generation Installation And User Instructions Manual

DCN NG | Installation and User Instructions | Section 5 | System Installation en | 132

25.3 Block-mounting

25.3.1 Introduction
The block-mounting method is used to install
flush-mounting units in panels of 2 mm. This method
uses couple pieces (LBB4127/00) to secure the units in
cut-outs in table-tops or the armrests of seats. See
figure 25.4 for an example of block-mounting a channel
selector (LBB4124/00).
25.3.2 Cut-outs
This section shows the dimensions of the cut-outs that
must be made for block-mounting the available
flush-mounting units.
140
121.5±0.5
figure 25.3: LBB4124/00 Channel Selector
Bosch Security Systems | 2004-03 | 9922 141 70521en