Intake Air Temperature Sensor (Iat Sensor) - Suzuki Jimny Service Manual

Intake air temperature sensor (IAT sensor)

REMOVAL
1) Disconnect battery negative cable at battery.
2) Disconnect connector from IAT sensor (1).
3) Remove IAT sensor (1) from air cleaner case (2).
INSPECTION
Immerse temperature sensing part of IAT sensor in water (or ice)
and measure resistance between sensor terminals while heating
water gradually.
If measured resistance doesn't show such characteristic as
shown in left figure, replace IAT sensor.
INSTALLATION
Reverse removal procedure noting the following.
• Clean mating surfaces of IAT sensor and air cleaner case.
• Connect IAT sensor connector (1) securely.
ENGINE AND EMISSION CONTROL SYSTEM 6E-31