Fuel Pressure Regulator - Suzuki Jimny Service Manual

6E-24 ENGINE AND EMISSION CONTROL SYSTEM
3) Fuel pressure should be felt at fuel feed hose (1) for 2 sec-
onds after ignition switch ON.
If fuel pressure is not felt, advance to "Diagnostic Flow Table
B-3" in Section 6.
REMOVAL
Remove fuel tank from body according to procedure described in
"Fuel Tank" of Section 6C and remove fuel pump from fuel tank.
INSPECTION
Check fuel pump filter for evidence of dirt and contamination. If
present, clean and check for presence of dirt in fuel tank.
INSTALLATION
1) Install fuel pump to its bracket.
2) Install fuel pump to fuel tank and then install fuel tank to
body according to procedure described in "Fuel Tank" of
Section 6C.

Fuel pressure regulator

ON-VEHICLE INSPECTION
Perform fuel pressure inspection according to procedure
described in "Fuel Pressure Inspection" of this section.
REMOVAL
1) Relieve fuel pressure according to procedure described on
"Fuel Pressure Relief Procedure" in Section 6.
2) Disconnect battery negative cable from battery.
3) Disconnect vacuum hose (1) from fuel pressure regulator
(2).
4) Remove fuel pressure regulator from fuel delivery pipe.
CAUTION:
A small amount of fuel may be released when it is from
delivery pipe.
Place a shop cloth under delivery pipe so that released
fuel is absorbed in it.
5) Disconnect fuel return hose (3) from fuel pressure regulator.