Steering Wheel - Suzuki Jimny Service Manual

Check air bag (inflator) module visually and if any of the following
is found, replace it with a new one.
• Air bag being deployed
• Trim cover (1) (pad surface) being cracked
• Wire harness (3) or connector being damaged
• Air bag (inflator) module being damaged or having been
exposed to strong impact (dropped)
2. Inflator case
INSTALLATION
1) Check that horn wire is connected to horn terminal securely.
2) Connect yellow connector (1) of driver air bag (inflator) mod-
ule (3) pushing connector till it is locked.
3) Install driver air bag (inflator) module to steering wheel, tak-
ing care so that no part of wire harness is caught between
them.
4) Make sure that clearance between module and steering
wheel is uniform all the way.
5) Tighten driver air bag (inflator) module mounting bolts (1) to
specified torque.
Tightening torque
Driver air bag (inflator) module mounting bolts
(a) : 9 N·m (0.9 kg-m, 6.5 lb-ft)
6) Install steering wheel side cap (2).
7) Connect negative battery cable.
8) Enable air bag system. Refer to "Enabling Air Bag System"
under "Service Precautions" in Section 10B.

Steering Wheel

CAUTION:
For vehicle with air bag system
Removal of the steering wheel allows the contact coil to
turn freely but do not turn the contact coil (on the combi-
nation switch) more than allowable number of turns
(about two and a half turns from the center position
clockwise or counterclockwise respectively), or coil will
break.
STEERING WHEEL AND COLUMN 3C-5